Build log

Electrical guides

Plain answers to the calculations electricians do on site: wire size, voltage drop, conduit fill and box fill, each with the NEC section, the working and an example you can check.

8 AWG or 6 AWG for 50 amps? Why two wire size calculators give different answers

8 AWG or 6 AWG for 50 amps? The same circuit comes out as 8, 6 or 4 AWG depending on the calculator. Seven hidden defaults explain it, with one worked circuit.

#electrician-calc

Box fill calculation: how to count conductors, devices and grounds (NEC 314.16)

How to calculate box fill by NEC 314.16: count conductors, clamps, devices and grounds in cubic inches. Three worked examples, one with 12 and 14 AWG together.

#electrician-calc

How to calculate conduit fill, with examples for mixed wire sizes (NEC Chapter 9)

How to calculate conduit fill: wire area divided by conduit area, 40% for three or more wires, 31% for two, 53% for one. Four examples, including mixed sizes.

#electrician-calc

AWG vs mm²: which metric size replaces which AWG, and why the ampacity does not convert

2.5 mm² sits between 14 and 12 AWG, and 12 AWG is 3.31 mm². Which size to pick in each direction, and why NEC and IEC allow different amps on the same copper.

#electrician-calc

Continuous load and the 125% rule (the 80% breaker rule): when it changes the wire and the breaker

A continuous load runs at full current for 3 hours or more. The NEC sizes its wire and breaker at 125%, which is the 80% breaker rule. Which loads count.

#electrician-calc

How to size wire by the NEC, step by step: ampacity table, temperature, derating and voltage drop

How to size wire by the NEC in 8 steps: load, breaker, 60/75/90 °C column, Table 310.16, derating, voltage drop and ground. With one full worked example.

#electrician-calc

Voltage drop: 3% or 5%? What the NEC says and how to calculate it

Is 3% voltage drop an NEC rule? The code recommends 3% on a branch circuit and 5% with the feeder, and requires it only in a few cases. Formula and examples.

#electrician-calc